Manufacture

Power Control Centre Vertical's PCC


Power Control Centre is used for distribution and control of various power source used in industry. Normally Power Control Centers is installed near power source hence fault level is high. It is designed to suit fault level of 50KA or 65 KA for 1 sec. Busbar system in Power Control Centers are designed to suit the fault level as well as temperature rise to 40°c above ambient. Ample space is provided for cable termination. Various protections like short circuit, overload, earth fault, under voltage etc are provided to protect source and equipment.


Application Specification
Type Fixed/Draw out fully componential, dust and vermin proof
Rated Volatge 600 V, 50 HZ, 3 phase, 4wire
Rated Frequency 50Hz
Rated Current Up to 6000A main busbar
Rated Short Circuit STD 50 KA 1 sec , Optional 65 KA 1 sec
Bus bar Support DOUGH MOULDING COMPOUND (DMC), SHIELD MOULDING COMPOUND (SMC) EPOXY RESIN, HYLAME SUPPORT
Bus bar Chamber Aluminium / Copper, Electrolytic grade
Construction CRCA 10 / 12 / 14 / 16 Guage as required.
Access Single Front (Front) or Double Front ( Front & Rear)
Installation With Space on Front as well as Rear
Cable Entry Bottom or Top
Dimension of Section Width – 600 / 800 / 1000 / 1200 / 1400mm / Height – 2250 / 2350 mm / Depth - 1000 / 1200 / 1400mm
Protection IP 4X
Internal Partitioning Form 3-B
Form of Separation As per customer requirement
Ambient temperature 40 degrees Celsius